Home / Case studies / Potterton Flamingo 2 to Worcester 2000 in Dunfermline

Case study: gravity system to combi conversion 10 November 2026 · 5 minute read

Potterton Flamingo 2 replaced with a Worcester Bosch 2000 in Dunfermline

A Potterton Flamingo 2 on a gravity fed heating and hot water system, wasting gas with no parts left, converted to a sealed pressurised system with a Greenstar 2000 combi.

  • 1980sWhen the old boiler went in
  • 2Days on site, tanks and cylinder out
  • 2000Worcester Bosch Greenstar combi fitted
Watch the job

This was a Potterton Flamingo 2 in Dunfermline, dating back to the 1980s. Credit where it's due, it had done well to last that long. But it was wasting gas, and parts for it were impossible to find.

We still come across one of these every so often, usually in a house that's had the same owner for years. They're built like a tank and they keep plodding on, which is exactly why people hang onto them. The problem isn't that they stop working. It's what they cost you while they're working, and what happens on the day they finally don't.

When a boiler that old breaks down, there's often no fix at all, only a cold house while you wait for a new one. Better to replace it on your own terms, so that's what we did.

This wasn't a straight swap. The house was on a gravity fed system, so the whole thing was converted to a sealed pressurised system running off a combi. It took two days, the same as most of our combi swaps, because the cylinder and tanks came out too.

Project summary

Location
Dunfermline
Removed
Potterton Flamingo 2, cylinder and loft tanks
Installed
Worcester Bosch Greenstar 2000 combi
System
Gravity fed, converted to sealed and pressurised
Why
Wasting gas, no parts available
Time on site
Two days
The job01

Why old boilers waste gas

Boilers from the 1980s aren't condensing boilers. A lot of the heat from the gas goes straight out of the flue instead of into your radiators. You're paying for all of it either way.

Modern boilers like the Greenstar 2000 are built to grab back as much of that heat as they can, which is why they're A rated for efficiency and the old ones aren't. You won't feel the difference in the house, because warm is warm. You feel it on the bill.

The other thing that happens with age is the controls. An old boiler is usually running on an old timer and a basic room thermostat, firing flat out every time it's asked for heat. Newer boilers modulate, which means they turn themselves down and tick over instead of going full blast and then stopping. Less on and off, steadier heat, less gas.

The parts problem

This is the one that catches people out. Manufacturers only make parts for a model for so long, and once they stop, that's it. One failed part can mean the whole boiler has to come out, often when the weather is coldest.

At that point you're not choosing a boiler, you're taking whatever can be fitted quickest. Replacing it while the old one is still going means you pick the boiler, you pick the day, and you're not waiting in the cold for a slot.

What a gravity system is, and why we converted it

A gravity fed system is how most houses were plumbed before the 1990s. There's a hot water cylinder in the airing cupboard and a tank or two up in the loft, and the water moves round partly under its own weight rather than being pushed by a pump at pressure.

It works, but it's slow to heat, the hot water runs out once the cylinder is empty, and the pressure at the taps and shower is only as good as the height of the loft tank. You're also heating a full cylinder of water whether you use it or not.

A sealed pressurised system does away with the tanks and the cylinder. The system is filled, sealed and held at pressure, and with a combi the hot water is heated on demand straight off the mains. The upshot is better pressure at the shower, hot water that doesn't run out, no tanks in the loft to freeze or leak, and nothing sitting there being heated for no reason.

It's more work than a straight swap. The old cylinder and tanks come out, the pipework is altered, and the system has to be cleaned and tested properly before it's sealed up.

Why the Greenstar 2000

It's a compact, quiet combi that's great value for smaller homes with one bathroom. It heats and makes hot water just as well for a smaller home, with fewer extras, so there's no point paying for a bigger boiler than the house needs.

If you've got two bathrooms or a big family all showering at once, we'd point you further up the range. Our Worcester Bosch page explains the differences without the sales patter.

Why old boilers waste gas02

What we did

Stripped out

The old boiler came off the wall, and the hot water cylinder and loft tanks that went with it were taken out too.

Pipework altered

The gravity pipework was reworked for a sealed pressurised system running off a combi, with the mains brought to the boiler for the hot water.

System cleaned

Decades of sludge and debris don't do a new boiler any favours, so the system was cleaned out before anything new went on it.

New Greenstar 2000

The Worcester Bosch Greenstar 2000 was fitted and connected up, with the pipework run in neatly underneath.

Pressurised and tested

The system was filled, sealed, brought up to pressure and checked over for leaks.

Commissioned

The boiler was tested, set up and registered with Worcester Bosch, and the customer was shown how to use it before we left.

What we did03

Before and after

Before: Potterton Flamingo 2 boiler in a home in DunfermlineBefore
After: Worcester Bosch Greenstar 2000 combi fitted in DunfermlineAfter

The Potterton Flamingo 2 that came out, and the Worcester Bosch Greenstar 2000 that went in.

Before and after04

Is it worth replacing a boiler that still works?

Not always, and we'll tell you if it isn't. A ten year old boiler that's running well and still has parts available is usually worth keeping and servicing.

It's a different conversation once you're into this territory:

  • Twenty years or older
  • Parts hard to find
  • Repairs getting bigger
  • Noisy or slow to heat
  • No guarantee left

If you're not sure which side of the line yours sits on, the quickest way to find out is to get someone to look at it. An engineer can usually tell you on one visit whether it has years left in it. Our repair or replace guide explains what to weigh up.

Is it worth replacing?05

Common questions

How long does a boiler last?

Most boilers are designed for around 10 to 15 years. Plenty go on longer, especially the older heavyweight ones, but once you are past 15 the parts start getting scarce and the running costs climb.

Can you still get parts for a 1980s boiler?

Usually not. Manufacturers stop making parts for a model after a certain number of years, and once they are gone one failed component means the whole boiler has to be replaced.

Will a new boiler cut my gas bill?

It should. An old non-condensing boiler sends a lot of the heat straight out of the flue, where a modern A rated boiler keeps much more of it in the house. How much you save depends on the old boiler, the house and how you run the heating.

How long does it take to replace a boiler?

Most combi swaps take 2 days, including a full system clean. A conversion like this one usually takes about the same, sometimes longer. We tell you which it is before anything is booked in.

Can any house be converted to a combi?

Most can, but not all. It depends on how many bathrooms you have, how strong the mains water supply is and how the house is piped. We check all of that at the survey and tell you if a combi is the wrong answer for your house.

What happens to the cylinder and the loft tanks?

They come out. That frees up the airing cupboard and takes the tanks out of the loft, which is one less thing to freeze or leak. Any pipework left behind is capped off properly.

Do I need my radiators replaced too?

Not normally. The system is cleaned out before the new boiler goes on, and a filter keeps the muck out afterwards. Radiators only need changing if they are leaking or badly corroded.

What guarantee comes with the boiler?

We are a Worcester Bosch Accredited Installer, so the boilers we fit come with guarantees of up to 12 years, parts and labour. The exact length depends on the model, and we tell you what yours comes with when we quote.

Can I get a quote without someone coming out?

Yes. The online quote takes about two minutes and gives you a guide price straight away. We confirm it with a free survey before any work is booked in.

Common questions06

New boilers in Dunfermline and Fife

We replace old boilers across Dunfermline, Rosyth, Crossgates, Cowdenbeath and the rest of Fife, plus South Queensferry, Kirkliston and Winchburgh. If yours is from a different decade, it's worth getting a price so you know where you stand. Our online quote takes about two minutes, and we confirm a fixed price after a free survey.

Related pages

Share this page WhatsApp Facebook LinkedIn Email
Related pages07

Not sure what you need? Give us a shout.

Book online in a couple of minutes or give the office a call, Mon to Fri, 9am to 5pm. We'll tell you what we think, and if the answer is to leave things as they are, we'll say that too.

i

Worcester Bosch Accredited Installer

Guarantees of up to 12 years on the boilers we fit. Gas Safe registered. Fife Trusted Trader. 400+ customer reviews.